Water as a renewable and free self-sustaining energy source for your cottage or home
Getting Off Oil, World news Saturday, April 20th, 2013There is a way to generate free self-sustaining electrical energy for your cottage or home using water. The system generates free energy without contaminating the water, consuming it or wasting it. You don’t even have to collect or store water. It produces no carbon emissions. It generates more electrical power than any solar panel or wind turbine and you can build it using parts salvaged from an automotive scrap yard. The water flow generator uses free flowing water from streams or rivers to generate renewable and free self-sustaining electrical energy.
You can construct a water flow generator yourself in a weekend using salvaged automotive parts that you can acquire very cheaply from any one of the thousands of automotive scrap yards. You can use a car’s rear axle assembly or utility trailer axle assembly as they both already have a hardened steel drive shaft and bearings installed to allow the axle to turn freely.
The axle assembly is coupled with another automotive part that has for decades, generated electrical current to power every car and truck’s electrical system and simultaneously recharge the vehicle’s battery – an alternator. An alternator is an electromechanical device that converts mechanical energy to electrical energy in the form of alternating current. The water flow supplies the mechanical energy by causing the fins of the water flow generator to be pushed downward in a counter-clockwise rotation. As the fins are forced downward with the water flow is causes the attached axle to rotate which causes the coupled rotor of the alternator to rotate in sync and generate free renewable self-sustaining electrical energy.
Attach all of these salvaged parts to a concrete slab that you can make yourself or have a cement company fabricate one for you. Cheaper if you make it yourself. You can also make the base, to which the drive shaft and alternator are attached, out of wood timber. Concrete is advised as it is heavier and is less likely to move with the water flow. If you use wood timber you will have to anchor it in place by driving supporting posts into the ground and build the base to the posts – like you would do if you were building a fence or raised cottage.
The system is ideally laid in a free flowing stream or you can construct it a short distance and parallel to a free flowing stream and divert (channel) some of the stream’s water flow to it and over it. That way you don’t disturb the natural downstream flow of the stream and you can build the system without having to dam the stream or get wet building it. When you dam a stream you cut off the water supply for your neighbours and wildlife downstream. That could get you in a lot of trouble with your neighbours and inadvertently alert the government crooks to the fact that you are building something without their extortion racketeering permission.
The heart of the water flow generator system is the mass produced automotive alternator. If a car or truck’s alternator can generate electrical current to power all of your vehicle’s electrical systems and simultaneously recharge your vehicle’s battery it can also generate electrical current to power the lights and appliances, and electrical gadgets (laptop) in your cottage or home and simultaneously recharge all your batteries (cell phone, laptop, iPad) – for free. An alternator is a compact and portable electrical power generator. They were developed and installed in every gas combustion vehicle ever made to perform one purpose – generate electrical power for the vehicle. Today, the alternator can be used to perform that exact same purpose – generate electrical power but for your cottage or home. As long as the water flows freely and turns the blades of a water flow generator it will generate free self-sustaining electrical power. Since you are dealing with water an alternator is the perfect electrical power generator for the job as they were intentionally built to operate in a wet environment – in your vehicle’s engine comportment which is exposed to the wet environment of snow and rain.
Towns and cities around the World can use this technology to produce their own electrical energy on site. Just make it bigger and instead of an alternator attach a generator from a stripped down (remove the diesel engine, fuel tank, and other diesel fuel engine parts) diesel generator to the system. For added electrical power generation just add more of these water flow generators downstream. Your neighbours downstream can also build their own and generate free energy for their needs as no water is being taken by the water flow generator upstream. The water is allowed to flow naturally and undiminished. Cities and towns can construct many of these along the rivers and streams that pass through their municipalities. As the rivers and streams flows differently through them they need only make a small modification to the design. Build the system so that the generator is raised above the water in such a manner that the fins are slightly immersed in the water along the shore and let the water current interact and turn the drive shaft and generate renewable and free self-sustaining electrical power.
The system can be easily modified. Don’t have a free flowing stream nearby- use your town or city’s drainage system and generate electrical power. Cities can cut costs simply by generating their own electrical power throughout the city. Cities have a constant – 24/7/365 days a year – flow of sewage and black water flowing just beneath their streets. Cities can take advantage of this and generate supplemental electrical power just by installing a water flow generator in manholes throughout the city.
Cities can generate electrical power to power street cars, street lights or recharging outlets for the city’s fleet of all-electric vehicles using a drain pipe water flow generator. The infrastructure is already there to turn any city into a carbon free, smog free environment.
Short URL: https://presscore.ca/news/?p=8018
Cities and towns around the World can easily adapt the system and utilize the flow of black water through their municipalities. They can install water flow generators inside existing drainage culverts or build and bury an entirely new system (a renewable energy pipeline) under their parks or roads and generate their own electrical power from black water.
During the construction stage incorporate a baffle into the design of each of the concrete sections to control the flow of the black water and prevent water levels from flooding the water flow generators. Baffles will also prevent debris in the system from coming into contact with and cause damage to the water flow generators.
More designs by Paul W Kincaid, of the Water Flow generator can be viewed at http://kincaids.ca/water%20generator/
Cities around the World can take advantage of their canals and waterway systems and generate clean renewable electricity. A waterwheel generating system can be constructed all along the Mississippi River, the Don Valley, the Saint John River, the Saint Lawrence, the River Thames, the Amazon, the Rhine, the Nile, Yangtze River and other fast flowing rivers and generate carbon free electrical energy.
In the above design, by Paul W Kincaid, the railing allows the public to enjoy the harbor view and at the same time provide a conduit that connects all of the water flow generators.